Stellar Industries SI-75 Manual do Utilizador descarregar pdf (Página 44)

 Stellar Cable Hoist Owner’s Manual

Match drill fenders and attach

3/8” bolt, flat washers and locknut.

Weld front braces to

cylinder mounting plate.

Position fender to allow

for max walking beam travel.

Notch out if needed.

Position fender to allow

adequate clearance between

fender and hydraulic cylinder

in upright extended position.

Weld center support to sub-frame.

After fender has been located properly,

locate and weld fender support.

Weld rear fender

mounts to bumper.

Weld on end caps.

(8)

Plastic Tandem/Tri-Axle

Right Front

Fender Brace

Left Front

Fender Brace

Drill 1/2” hole for wire

harness - both sides.

1/2” diameter hole -

Both mounting weldments.

Wire Harnerss (2)

2” Rubber Grommet (2)

2” Beehive Sealed Light (2)

Step 13: Mid-Body Light Installation

Step 12b: Fender Installation - Plastic Tandem/Tri-Axle

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 93 94

Sem comentários

Stellar Industries SI-75 Manual do Utilizador Página 44